Projects

All Instruction Projects
【Review】SainSmart Upgraded ToolPAC PRO32 Soldering Tool Kit

【Review】SainSmart Upgraded ToolPAC PRO32 Solder...

Hello guys, because every pilot need a soldering iron, I thought that could be useful to you if I show you my soldering iron. At any racing drone you have...

【Review】SainSmart Upgraded ToolPAC PRO32 Soldering Tool Kit

Posted by SainSmart on

Hello guys, because every pilot need a soldering iron, I thought that could be useful to you if I show you my soldering iron. At any racing drone you have...

View More
Nunchuk Controlled SainSmart 6-Axis Robotic Arm with Arduino

Nunchuk Controlled SainSmart 6-Axis Robotic Arm...

 Robotic arms are awesome! Factories all over the world have them, where they paint, solder and carry stuff with precision. They can also be found in space exploration, subsea remote...

Nunchuk Controlled SainSmart 6-Axis Robotic Arm with Arduino

Posted by SainSmart on

 Robotic arms are awesome! Factories all over the world have them, where they paint, solder and carry stuff with precision. They can also be found in space exploration, subsea remote...

View More
Tags: Instruction , Projects

How to update the USB Firmware of Arduino DUE?

What you need: 1x PC 1x SainSmart Due Atmel SAM3X8E ARM Cortex-M3 board 1x SainSmart UNO R3 ATmega328P Development Board Compatible With Arduino UNO R3 1x 1uF Capacitor Jump wires...

How to update the USB Firmware of Arduino DUE?

Posted by SainSmart on

What you need: 1x PC 1x SainSmart Due Atmel SAM3X8E ARM Cortex-M3 board 1x SainSmart UNO R3 ATmega328P Development Board Compatible With Arduino UNO R3 1x 1uF Capacitor Jump wires...

View More

SainSmart 3D Printer Build #7

September 9th, 2013 Knowing how crucial the z-axis calibration and alignment is, I focused on that today. I manually rotated the z-axis rods to get even pressure on all of...

SainSmart 3D Printer Build #7

Posted by SainSmart on

September 9th, 2013 Knowing how crucial the z-axis calibration and alignment is, I focused on that today. I manually rotated the z-axis rods to get even pressure on all of...

View More

SainSmart 3D Printer Build #6

September 7th, 2013  I mounted the extruders, turned on the heaters and attempted to run some filament through them, only to find that the barrels were getting hot enough to...

SainSmart 3D Printer Build #6

Posted by SainSmart on

September 7th, 2013  I mounted the extruders, turned on the heaters and attempted to run some filament through them, only to find that the barrels were getting hot enough to...

View More

RECENT ARTICLES